The trigger isn’t going to reset, when you have your finger on it, depressed- like you show in the video. Or maybe I’m confused with what you wrote and show in your video??? Disassemble, clean firearm and parts. Check rails with a leveler, what marine gun builder videos, then you should be good to go.
Definitely lacking sear engagement. Sounds like the cruciform is slipping right off that firing pin.
Did everything except armors plate didn’t have one then but I just ordered one will also check the connector thanks for the advice
If you haven't properly fixed your rear rail, that's probably your problem. That fix, and a few others, are all linked in the pics in the
This. I think the majority of polymer80s is the trigger housing assembly sits too high. So the rails sit high and I don’t think your sear is engaging
Keep it like that free full awesomeness 😝
It’s my edc I can’t trust it like this it was fun to get yelled at the gun range lol
Don’t carry this until you’ve put well over 1k rounds thru it without issue
If it’s from the 80pbuilder kits I would highly suggest getting an OEM trigger housing and trigger bar. I had the same issue and this fixed it 100%
Check of your firing pin broke.
The trigger isn’t going to reset, when you have your finger on it, depressed- like you show in the video. Or maybe I’m confused with what you wrote and show in your video??? Disassemble, clean firearm and parts. Check rails with a leveler, what marine gun builder videos, then you should be good to go.
I had the same thing happen with my Pf9ss. I changed the connector and trigger bar spring and now it’s working 👌🏼